Tan 45 Degrees : Exact Value, 1, and How to Find It

What Does Tan 45 Degrees Mean?

Tangent is one of the three core trigonometric ratios - in a right triangle, the tangent of an angle is the side opposite it divided by the side adjacent to it. So $\tan 45^\circ$ asks: in a right triangle with a 45° angle, how does the opposite side compare with the adjacent side?

On the unit circle - a circle of radius $1$ centred at the origin - the tangent of an angle is the slope of the radius drawn to that angle, or equivalently $\dfrac{\sin\theta}{\cos\theta}$. At $45^\circ$ the radius meets the circle at $\left(\dfrac{\sqrt{2}}{2}, \dfrac{\sqrt{2}}{2}\right)$, where the $x$- and $y$-coordinates are equal, so the slope is $1$.

Where Does Tan 45 Degrees Show Up?

A 45° angle is the classic "one unit up for every one unit across" slope - a staircase where each step rises as much as it runs, or a roof pitch drawn at an even diagonal. Because the rise equals the run, the slope is $\tan 45^\circ = 1$, which is why a 45° line on any graph has gradient exactly $1$.

The value also anchors the 45-45-90 set square used in drafting, whose two short sides are equal. In navigation and physics, a projectile launched at 45° splits its speed evenly between "up" and "forward," the balance point captured by trigonometric ratios of specific angles.

Standard-Angle Reference Table

Forty-five degrees is the crossover angle where tangent equals exactly $1$. Here are the standard first-quadrant angles in both degrees and radians.

Tan 45° is the dividing line: below $45^\circ$ the tangent is less than $1$, above it the tangent is greater than $1$. It is also the angle where $\sin\theta = \cos\theta$, which is exactly why their ratio comes out to $1$.

How Do You Find The Exact Value Of Tan 45 Degrees?

There are three clean routes, and all three land on $1$.

Method 1: The 45-45-90 triangle.

A right triangle with two 45° angles is isosceles — the two legs are equal. Call each leg $1$; then the side opposite the 45° angle and the side adjacent to it are both $1$.

$$\tan 45^\circ = \frac{\text{opposite}}{\text{adjacent}} = \frac{1}{1} = 1$$

Method 2: The unit-circle slope.

Tangent equals $\dfrac{\sin\theta}{\cos\theta}$. Using $\sin 45^\circ = \dfrac{\sqrt{2}}{2}$ and $\cos 45^\circ = \dfrac{\sqrt{2}}{2}$:

$$\tan 45^\circ = \frac{\sin 45^\circ}{\cos 45^\circ} = \frac{\sqrt{2}/2}{\sqrt{2}/2} = 1$$

Sine and cosine are equal here, so their ratio has to be $1$.

Method 3: The calculator check.

Set the calculator to degree mode and enter $\tan(45)$, which returns exactly $1$. Unlike $\tan 30^\circ$ or $\tan 60^\circ$, this one shows no trailing decimals because the value is the whole number $1$.

Examples Of Tan 45 Degrees

Example 1

Evaluate $7\tan 45^\circ$.

$$7\tan 45^\circ = 7 \times 1 = 7$$

Multiplying by $\tan 45^\circ$ leaves a number unchanged, which is a handy check.

Example 2

A right triangle has a 45° angle and the side adjacent to it measures $6$ cm. Find the side opposite the 45° angle.

Wrong attempt. A student reasons that since $45^\circ$ is "halfway," the opposite side must be half the adjacent side, giving $3$ cm.

That breaks against the definition: $\tan 45^\circ = \dfrac{\text{opposite}}{\text{adjacent}}$, and if the opposite were $3$ then $\tan 45^\circ$ would be $\dfrac{3}{6} = 0.5$, not $1$. "Halfway in degrees" does not mean "half the length."

Correct. Set $\tan 45^\circ = \dfrac{\text{opposite}}{6} = 1$, so opposite $= 6$ cm. In a 45° right triangle the two legs are equal, which matches.

Example 3

A ramp is built so that it rises $1$ m for every $1$ m of horizontal run. What angle does it make with the ground?

$$\tan\theta = \frac{\text{rise}}{\text{run}} = \frac{1}{1} = 1 \implies \theta = 45^\circ$$

Example 4

Show that $\tan 45^\circ = \dfrac{\sin 45^\circ}{\cos 45^\circ}$.

$$\frac{\sin 45^\circ}{\cos 45^\circ} = \frac{\sqrt{2}/2}{\sqrt{2}/2} = 1$$

The quotient identity holds, and because the two values are identical the result is $1$ by inspection.

Example 5

Express $\tan 45^\circ$ in radians and evaluate $\tan\left(\dfrac{\pi}{4}\right)$.

Since $45^\circ = \dfrac{\pi}{4}$ radians, $\tan\left(\dfrac{\pi}{4}\right) = \tan 45^\circ = 1$. The twin article tan π/4 opens from the radian and unit-circle side, but the value is the same $1$.

Where Students Trip Up On Tan 45 Degrees

Mistake 1: Thinking "45° is half of 90°" means the value is halved

Where it slips in: Reasoning about angles as if halving the angle halves the ratio.

Don't do this: Writing $\tan 45^\circ = \dfrac{1}{2}$ because $45^\circ$ is halfway to $90^\circ$.

The correct way: Tangent is not linear in the angle. It runs $0$ at $0^\circ$, $1$ at $45^\circ$, and off to infinity near $90^\circ$, so the midpoint angle does not give a midpoint value. The instinct to treat angle and ratio as proportional is the single most common source of wrong standard-angle values.

Mistake 2: Confusing tan 45° with sin 45° or cos 45°

Where it slips in: Recall under pressure, when the clean $1$ gets swapped for the $\dfrac{\sqrt{2}}{2}$ of sine and cosine.

Don't do this: Writing $\tan 45^\circ = \dfrac{\sqrt{2}}{2}$.

The correct way: $\sin 45^\circ = \cos 45^\circ = \dfrac{\sqrt{2}}{2} \approx 0.71$, but tangent is their ratio, so $\tan 45^\circ = 1$. Whenever you see $\dfrac{\sqrt{2}}{2}$ attached to a tangent, that is a sine or cosine value that wandered into the wrong slot.

Mistake 3: Forgetting the sign in the second quadrant

Where it slips in: Assuming every angle with a 45° reference gives $+1$.

Don't do this: Writing $\tan 135^\circ = 1$ because its reference angle is $45^\circ$.

The correct way: In the second quadrant tangent is negative, so $\tan 135^\circ = -1$ even though the reference angle is $45^\circ$. Its radian form, tan 3π/4, carries that same negative sign.

Key Takeaways

• Tan 45 degrees equals exactly $1$ - the crossover angle where the tangent switches from below $1$ to above $1$.

• The 45-45-90 triangle gives it as opposite over adjacent with two equal legs; the unit circle gives it as $\dfrac{\sin 45^\circ}{\cos 45^\circ}$, and sine equals cosine here.

• In radians, $\tan 45^\circ = \tan\left(\dfrac{\pi}{4}\right)$; in the second quadrant the same reference angle gives $-1$.

• The most common slips are halving the angle to "halve" the value and confusing $\tan 45^\circ$ with $\sin 45^\circ = \dfrac{\sqrt{2}}{2}$.

To take these standard angles further with a teacher, explore Bhanzu's trigonometry tutor, our high school math tutor sessions, or structured math classes online.

Practice These Before Moving On

1. Evaluate $3\tan 45^\circ + \tan 30^\circ$.

2. A path rises $1$ m for every $1$ m forward. Confirm the incline angle using $\tan\theta = 1$.

3. Show that $\tan 45^\circ \times \tan 45^\circ = 1$ and explain why the answer is unchanged.

Want a live Bhanzu trainer to walk through more tan 45 degrees problems? Book a free demo class — online, worldwide.

Read More

• Sin, cos, and tan — the three core trigonometric ratios

• The full trigonometric table of standard values

• Pythagorean identities and how they connect the ratios

• The unit circle and where every standard angle lives